Printable View
Anyone have any suggestions for one?
These are all over the place: http://www.pyramydair.com/customer-d..._Stop_Pin/2401
But they're listed as fitting both 3/8" or 11mm. Since 3/8s is ~9.5mm, that means the picatinny rail will be offset for either 11mm or 3/8s, so I'm hesitant to order one unless someone can tell me for sure that it's the 11mm that's centered.
Thoughts? Suggestions?
O2
Best bet is an Accuracy International dovetail scope mount. The AI dovetail and the rimfire rails are almost identical.
All of the adaptors I have played with suck.
The only one that was worth a crap was DIP.
Below AI rail.
http://farm8.staticflickr.com/7018/6...97ca48cd_b.jpg
What is it going on?
I have had good luck with BKL products as they clamp from each side.
http://www.bkltech.com/default.asp
Yhea, my apologies, some detail would help...Quote:
Originally Posted by newracer
Rifle: http://www.fxairguns.com/rifle/the-royale-500/
http://www.fxairguns.com/wp-content/...1-1024x353.jpg
Scope: http://www.atncorp.com/x-sight2-hd-d...le-scope-5-20x
http://www.atncorp.com/images/banner...ight_2_img.png
Application: Wabbits
Because of the scope, I can't use rings, unfortunately.
I just noticed that the magazine precludes the use of that mount, dangit. Might have to see if the single pellet loader would fit under it.
O2