Printable View
Hmm a bob dole blog would be kind of funny.
I hear you on that Bro it's been a bs week here too. Haven't done anything in the lawn at all yet. Got to call someone to give me that instant grass this year. Lawns already getting weeds and I just don't have time to deal with it.
Hey Mazin. How's it hanging bro?
You know that instant grass can found legally in lots of places now.
You have to register your scope ? ? ? Better start blocking those doomberg e-mails.Quote:
Originally Posted by Otterbatcat
well? what was it?Quote:
Originally Posted by BuffCyclist
From all the analysis and calculations.Quote:
Originally Posted by TheBelly
He didn't hold his mouth quite right.
Lobbed from my electronic ball and chain.
ugh.. I'm too tired to get the joke.
Quote:
Originally Posted by HoneyBadger
Ya just couldn't take the suspense, could ya?! [LOL]Quote:
Originally Posted by TheBelly
Okay, so using some small hole gages and a pair of very nice micrometers, I was able to determine that the primer pockets on the LC LR 07 brass was on the maximum end of specs, and the WLR primers were on the minimum end of specs. Without actually averaging (no time yet, just recorded lots of data), here's the results:
All of this data was taken from measuring between 10-20 cases/primers, and recording the measurement 3 times, the writing down the average of those 3 for all cases/primers. The same measurements between cases were VERY consistent.
LR Primers
Min = 0.2105"
Max = 0.2130"
LR Primer Pockets
Min = 0.2085"
Max = 0.2100"
CCI BR2 Primers - 0.2111" (middle of spec)
WLR Primers - 0.2103 (lower end of spec)
LC LR 04 Primer Pockets - 0.2094" (in spec)
LC LR 07 Primer Pockets - 0.2106" (above spec)
LC LR 08 Primer Pockets - 0.2097" (in spec)
LC LR 10 Primer Pockets - 0.2100" (max spec)
LC LR 11 Primer Pockets - 0.2095" (in spec)
R-P Primer Pockets - 0.2098" (in spec)
Black Hills Primer Pockets - 0.2100" (max spec)
I STILL don't have the Lapua brass, not happy with SouthwestAmmunition for that, they were in-stock when I ordered, then they claimed they must have sold out after I ordered even though the page still hasn't changed like some other items that say "Requires an additional 1-2 weeks processing time)". Anyways, I don't have that brass in yet so I can't measure the primer pockets to see what they are.
What I think happened is that the LC LR 07 primer pockets were a few ten thousandths (as in, as much as 0.0003"-0.0005" larger) larger than the primers, which caused less friction to hold the primer in place, so the primers were easier to unseat and blow out. When I get time, I'll be pulling the remaining 51rds, weighing charges to ensure that wasn't a contributing factor too but will then just load up the Lapua brass with a smaller range of powder charge and retest.
Oh and my Timney Trigger arrives today to fix the XMark Pro Trigger Recall problem. So that should be fun.
Missed me didn't you..:)
Oh god, not the pictures of tacos again! [facepalm]Quote:
Originally Posted by waxthis