The post whore thread.

Printable View

07-30-2014, 11:59
TheBelly

http://i994.photobucket.com/albums/a...ps00fbcdee.jpg

adding a looky-through plopped almost 2 lbs on it.... hoolyyyy crap!
07-30-2014, 13:20
HoneyBadger

Whew! I should weigh some of my rifles. I really have no idea how heavy they are.
07-30-2014, 13:47
TheBelly

My LMT MWS probably weighs about 14 lbs. They aren't light, that's for sure.
07-30-2014, 14:43
brutal

Quote:

Originally Posted by TheBelly

My LMT MWS probably weighs about 14 lbs. They aren't light, that's for sure.

My Sig 716P is 13.8 without the can and I'm going to be adding a SAPR when it gets here.

Have to re-weigh it but the glass is out at SWFA right now. Zoom ring post fell out unnoticed.
07-30-2014, 15:22
TheBelly

Quote:

Originally Posted by brutal

My Sig 716P is 13.8 without the can and I'm going to be adding a SAPR when it gets here.

Have to re-weigh it but the glass is out at SWFA right now. Zoom ring post fell out unnoticed.

isn't that a piston gun?
07-30-2014, 15:38
brutal

Quote:

Originally Posted by TheBelly

isn't that a piston gun?

That it is.

Had to go back to Sig after 3 rounds and then FTE/FTF.

They polished the chamber, deburred the gas port on the piston block, and gave it a nice free trigger job. Got an extra mag back with it too (pre-ban).

Now it's mostly good although picky with some ammo (PCI) with the can hanging off the end. Won't cycle old M80 ball Greek reliably in any config. Just need to keep banging rounds through it and keep the chamber clean.
07-30-2014, 16:44
TheBelly

how's the accuracy? (assuming you'd be doing a litle precision stuff with it.)
07-30-2014, 17:02
brutal

Quote:

Originally Posted by TheBelly

how's the accuracy? (assuming you'd be doing a litle precision stuff with it.)

1-1.5 MOA with ball ammo. Closer to 1MOA with my first M80 clone loads. Closer to 1MOA with my old retired Marine friend behind the trigger.

.75-1MOA with GMM It's only a 16" bbl.

Haven't found the time to start a workup for all the components I have here for .308

Needed to order the the SAPR to get off the chin weld. That Larue QD mount is great for clearing the iron sights, but it's too high for a good cheek weld.
07-30-2014, 17:05
TheBelly

yeah, I use a LT158 on my 7.62 gas gun. It's.....a little high.
07-30-2014, 17:23
brutal

Quote:

Originally Posted by TheBelly

yeah, I use a LT158 on my 7.62 gas gun. It's.....a little high.

LT104 - even higher but I wanted to keep the BUIS on the rifles. Pretty sure LT158 would not clear them.

I don't think any mount on any flat top will really be low enough for me with a standard AR stock for a decent cheek weld. I must have high cheekbones or low eysockets.