I got nothing I'm going to ask the wife. Bet you $10 she says blow it out.
Printable View
I got nothing I'm going to ask the wife. Bet you $10 she says blow it out.
Wife says it's a tension issue. Hey my wife just told me a shit load of stuff that I don't understand so the next post is from Mrs Mazin.
Take it away sweetie!
Hi this is Mrs. Mazin. So when I have had that happen on my sewing machine it is a tension issue if it is on the bottom of the project there should be a tension dial close to the needle. You will probably need to look up in the manual or online for that machine as to what the tension needs to be set to for the type of needle and what you are sewing on. I believe it usually needs to be a little higher for heavy thread. Hope that helps.
I ran the tension both directions and it didn't make a difference. I sewed like this for hours and hours, then all of the sudden this happens over and over.
Quote:
Originally Posted by Mazin
Sounds similar to a mig welder, or turning on a lathe. Speeds & feeds.Quote:
Originally Posted by Irving
I got a hot tip to look up "birds nest" issues and go from there. Sounds like it could be a number issues like broken needle tips, dirty, etc. So likely what Mazin was talking about with blowing it out. I'll check it out again after work today.
Blew out the machine, rethreaded the bobbin, and got to work finishing up version 2.0.
Glad you got it working. Maybe it was because yours didn't have a kevlar layer in it. ;)
This version does have a layer of water proofing. Well, kind of.
Water resistance? That's a big (relatively vague and undefined) selling point these days. I bet it's also shatterproof and organic.Quote:
Originally Posted by Irving