Mini Redneck Ramada

[Colorado_Outback]

Really cool! Are you going to build any sort of storage cabinet or anything under the sides of the camper (on top of the trailer deck)?

Yep going to make 2 boxes that slide in from the front and will have side doors on them. Still need to figure out how I'm going to execute the doors. Should be able to get the grill, jacks and some other junk in them. Ply, seam seal, and a good exterior paint. Probably black to match the trailer.

When a slide in is on the truck, you level the camper using the jacks. The issue with the heater noise might be attributed to it not level, or slightly tweaked prior to your project.

I had it (reasonably) leveled out when ever I was messing with the heater and on both occasions I had it out. It hasn't returned yet so fingers crossed.

When and if you extend the ball coupler / hitch, make sure the distance from center of both hubs / axle is even to the center of coupler. An uneven measurement can cause excessive tire wear, potential handling issues.

Good advice. Just went through re squaring the axle after the lift. If anything Ill probably build a custom drop hitch and add an inch or two there. Still need to do more research on that and figure out what the acceptable limit is. Since I'm effectively increasing the length of a lever arm with a 4-500lb weight on it, it turning into a taco would be tragic.