9 inch ring and pinion pattern

[2XS]

Hey do any guys feel like you could advise me on my ring pinion pattern on my 9 inch ford. I have the drive side good and the backlash set but the coast side pattern is right in the middle and very light. I can post pictures.
Just trying to figure out what I need to do or if it is good to go. Thanks guys .

[BPTactical]

Looks decent to me, maybe a touch low on the tooth. The most critical thing is that it is pretty well centered. It's when you have too much contact on either the heel or toe of the tooth you run into problems.
I will show your pics to our differential guy at work tomorrow and get his thoughts.
Get a couple of pics of the drive side if you can.

[Graves]

You have a better angle of the drive side?

[2XS]

http://s447.photobucket.com/user/cpu...470d.jpg.html][/URL]

[2XS]

Hope these are better

[vossman]

I don't even know wtf these pics are of. Transmission?

[Great-Kazoo]

I don't even know wtf these pics are of. Transmission?

Ring & pinion gears in rear differential, final part of the drive train, before the wheels.

[BPTactical]

Just had our differential guy look at your pics. He agrees, looks decent with a good pattern. Run it, check the noise level.
If a new ring and pinion keep the load light for the first couple hundred miles, give things a chance to burnish in.

[vossman]

Ring & pinion gears in rear differential, final part of the drive train, before the wheels.

Thanks for the info, never seen anything like that. I've always wished I could work on motors/cars without making the issues worse.

[sniper7]

Looks good.

it's a ford, so you might as well not worry, they break down a lot, it's just natural to the manufacturer.