Is he local to Colorado?

I think I'll fire up the dremel and take whack at it. How hard can it be?

To me, this is all about degrees of freedom. That was my point with Mike on THe Hide. It sounds like he has taken out a lot of variability on the mag side. To me the question is how much jiggle the conversions will have. I don't have any actual knowledge of what the cuts are. Throw in Chassis variation and I get nervous- mainly because it can become a three way firing circle of Mike (design), Mike (mags), the smith and the chassis. If you have issues..... I assume Mike will help out, but we all know what assuming does.

That is my low information, high interest view point.