Need someone with aluminum fab skills

[argonstrom]

I need a shifter for my Busa similar to this:

[ray1970]

Is that a heel/toe shifter?

[SideShow Bob]

It looks as if it is a cast piece.

Trying to to mill some thing similar out of bar stock would be prohibitatively expensive. Buying the part would be cheaper.

[crays]

Is that a heel/toe shifter?

It looks as if it is a cast piece.

Trying to to mill some thing similar out of bar stock would be prohibitatively expensive. Buying the part would be cheaper.

If you have access to some (scrap) stock and the proper equipment, that's a pretty easy/cheap part to fab.

Finishing to match...Whole other issue.

ETA: the splines at the attach point will definitely add time and cost.

[crays]

And I'm just talking about the arm/lever, not the pegs and rubber (probably inexpensive stock parts anyway).

[argonstrom]

Is that a heel/toe shifter?

Yes sir.

It looks as if it is a cast piece.

Trying to to mill some thing similar out of bar stock would be prohibitatively expensive. Buying the part would be cheaper.

If it was available for retail purchase, I'd have have pluncked down my cash.

[argonstrom]

If you have access to some (scrap) stock and the proper equipment, that's a pretty easy/cheap part to fab.

Finishing to match...Whole other issue.

ETA: the splines at the attach point will definitely add time and cost.

With regard to the shifter, I'm all about function at this point.

[SideShow Bob]

Well here's your chance to corner a niche market, have a fab shop make you a dozen or so. Keep one and sell the rest. Yours will end up being free and you will have a nice wad of cash from selling the rest.......

[2XS]

To me it looks like the heel part of that shifter was added on to the stock shifter welded on smoothed out and powder coated. Looks like an easy part to fab with a water jet an TIG welder.

[Great-Kazoo]

What's the spline dia. and # of teeth? I have a beemer r1100rt (maybe) in the scrap pile. That's what it looks like to me.