Need HVAC/Furnace Help - Furnace Dead

[asmo]

So a few weeks ago I bought a fancy new Ecobee3 thermostat to replace the Honeywell that I had. I hooked it up and everything worked great except the original builder only ran 18-5 between the thermostat and the furnace - so I couldn't hook up the humidifier since I didn't have enough wires (the old Honeywell used a THM5421C EIM to go from 7 wire to 3). So no big deal we went without a humidifier for a few weeks until I could run some 18-10 between the thermostat and the furnace (and humidifier).

So flash forward to last night. I run some 18-10 between the thermostat and the furnace (no easy task). I hook all the wires up and nothing - furnace wont even power on. I check all my wiring and the safety switch and everything looks good. I test for voltage across C and R at the furnace and I get nothing. I jumper R/W and nothing, I jumper R/G/W and still nothing. I do hear 120AC going into the furnace (hum), but it doesn't translate into anything. I also don't get any lights on the furnace control module.

Anyone want to help my understand what the hell I am doing wrong. I really hope that the furnace control module didn't puke just because I put some new wires in.

This is the furnace end before I started:


This is the furnace end after I replaced the 18-5 with 18-10:


In both of the above, the top W (going to Y) and the bottom B are going to the safety switch.


This is the thermostat end (no difference before and after other than different wires -- still the same colors):


This is the furnace control module (its a RUUD):



Any thoughts? I really don't want to have to pay for a Sunday emergency call, but I leave tomorrow and need to have heat in the house before I go.