11mm dovetail to Picatinny rail adapter.

[O2HeN2]

Anyone have any suggestions for one?

These are all over the place: http://www.pyramydair.com/customer-d..._Stop_Pin/2401

But they're listed as fitting both 3/8" or 11mm. Since 3/8s is ~9.5mm, that means the picatinny rail will be offset for either 11mm or 3/8s, so I'm hesitant to order one unless someone can tell me for sure that it's the 11mm that's centered.

Thoughts? Suggestions?

O2

[Hoser]

Best bet is an Accuracy International dovetail scope mount. The AI dovetail and the rimfire rails are almost identical.

All of the adaptors I have played with suck.

The only one that was worth a crap was DIP.

Below AI rail.

[newracer]

What is it going on?

I have had good luck with BKL products as they clamp from each side.

http://www.bkltech.com/default.asp

[O2HeN2]

What is it going on?

I have had good luck with BKL products as they clamp from each side.

http://www.bkltech.com/default.asp

Yhea, my apologies, some detail would help...

Rifle: http://www.fxairguns.com/rifle/the-royale-500/



Scope: http://www.atncorp.com/x-sight2-hd-d...le-scope-5-20x



Application: Wabbits

Because of the scope, I can't use rings, unfortunately.

I just noticed that the magazine precludes the use of that mount, dangit. Might have to see if the single pellet loader would fit under it.

O2