Cerekote

[Cospringfield]

I might check into them on a couple of lowers. Do you know if they do engraving also? Or someone that does metal engraving?

[Mazin]

I have a buddy that had to move his shop but should be setup in the new location by the end of next week if you're still in need I can hook you up with his info.

[00tec]

I've been wanting to try cerekote with an airbrush. I was hoping to not have to sandbags it though.
Does anyone have experience cerekoting after cleaning with lye and acetone, like when anodizing?

Since cerakote is like a paint, rather than a chemical process, you really do need to get some abrasion on the surface

[Mazin]

^100% Correct
To have optimal adhesion you will want to sand blast your parts first.

[ChickNorris]

^100% Correct
To have optimal adhesion you will want to sand blast your parts first.

Wrong pronoun




Giggle

[Cospringfield]

Good point, was hoping to get away with scotch bright pads, but maybe not worth chancing all that effort and then half assing the prep work.