Close
Results 1 to 10 of 11

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 02-11-2021, 18:32 #1
    Erni
    Erni is offline
    Machine Gunner
    Join Date
    Jan 2007
    Location
    Longmont, CO
    Posts
    2,181

    Default

    So it looks like you need the hex file adopted for a servo which I assume you have. Then on his page it says to configure the setup with $$ when you are connected to the printer. In there are the settings. Did you get that part done?
    Reply With Quote Reply With Quote
  2. 02-11-2021, 21:19 #2
    DFBrews
    DFBrews is offline
    Beer Meister DFBrews's Avatar
    Join Date
    Dec 2010
    Location
    With the classyish Hipsters...Stapleton
    Posts
    3,175

    Default

    Quote Originally Posted by Erni View Post
    So it looks like you need the hex file adopted for a servo which I assume you have. Then on his page it says to configure the setup with $$ when you are connected to the printer. In there are the settings. Did you get that part done?
    Yup I have tweaked all of $$ to my specific machine
    size feed rate steps etc.
    The area I am dealing with is going be solved in the spindle.h file area
    I don’t enough to start with base grbl and make my servo go up and down.


    It might happen soon though
    Last edited by DFBrews; 02-11-2021 at 21:21.
    You sir, are a specialist in the art of discovering a welcoming outcome of a particular situation....not a mechanic.

    My feedback add 11-12 ish before the great servpocaylpse of 2012
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules