Can someone 3D print me a part?

[Irving]

I made it work. I can post photos later.
Thank you everyone for suggestions and offers to help.

[Irving]

One of my buddies asked which trans and after a quick Google search, found me the part I needed from a Jeep AX15 transmission. I ordered it in, and the outside diameter was perfect, but the inside was too large and it wouldn't stay on the ball.


If you remember that I broke a gear doing my low gear install, and had to go get a second transfer case to cannibalize. I had that hi-lo shifter laying around and noticed that it had a plastic sleeve on it that looked like would fit the new bushing I got from Core Shifters. I used the hot knife trick again and cut this off the old shifter. Even after cutting it was a bear to get off and back onto the other shifter. Since this very clearly didn't have to slide around or move at all, I just super glued the whole thing together and held it in the vise again.


It was a tight fit, but I got the new bushing over the top and now everything is back to normal. Finally!