Reloading Bench Build

[JohnnyEgo]

Slapped the sled on the table saw and started trimming:


Then cut some drawer bottoms:




Marked them out for Domino holes, and then taped up the edges; I have learned that my Domino cutter is not real kind to face veneer and tends to blow it out near the edges of thru-domino mortises.





Then carved a lot of domino mortises.




Made some custom dominos out of the trim I'd previously glued up:


And drove them home:

[JohnnyEgo]

I am using Promark slides, which are much more economical knock-offs of Accurides. Made a spacer to make sure the mounts were consistent.


Also countersunk to accomodate a #8 screw:






Busted out the hardware positioning tool to keep things relatively consistent between drawer mounts for the pulls"






And picked a pretty board I've been saving for a while to make some drawer fronts: