Welcome to the Colorado AR-15 Shooters Club Discussion Forums.
Bedding a Manners
I bought a used Manners stock with mini chassis, and the seller said it hasn't been bed. It actually has been bed so my TL3 won't even fit in it because the recoil lug is a bit too wide. Any suggestions for removing the bedding compound? Would I need to rebed it or would I be able to just remove enough compound so the recoil lug will fit?
Last edited by shooter_mcgavin; 01-09-2024 at 11:36.
Take some measurements and see where material needs to be removed. Guessing the sides and muzzle end of the bedding around the recoil lug.
You might be able to get a dental pick under it and flick it out, but I doubt it.
You know I like my coffee sweet in the morning
and I'm crazy about my tea at night
That looks pretty poorly done, there is no support of the barrel ahead of the recoil lug and little behind it. Bedding just the lug does little. The goal of bedding is to create a totally homogeneous fit between the stock and receiver, essentially making it one.
You gotta do the nasty for the best results- get busy with your dremel and remove as much of the existing bedding and redo it (or have it redone).
The most important thing to be learned from those who demand "Equality For All" is that all are not equal...
Gun Control - seeking a Hardware solution for a Software problem...
It’s easier than it looks to bed it. Watch some videos. You can’t make it worse than it is.
"It takes considerable knowledge just to realize the extent of your ignorance"
Thomas Sowell
www.timkulincabinetry.com
See our reviews below:
http://www.thumbtack.com/Tim-Kulin-C...service/788419
Dont forget to contact the seller and kick him in the nuts.
You know I like my coffee sweet in the morning
and I'm crazy about my tea at night
Well he could always glue the action to the stock.....Originally Posted by Tim K
The most important thing to be learned from those who demand "Equality For All" is that all are not equal...
Gun Control - seeking a Hardware solution for a Software problem...
Well Bert, you got me there!
"It takes considerable knowledge just to realize the extent of your ignorance"
Thomas Sowell
www.timkulincabinetry.com
See our reviews below:
http://www.thumbtack.com/Tim-Kulin-C...service/788419
Wipe it all down with acetone first, then use JB Weld as your "bedding compound". Use 2x more than you need, since when it oozes out you can just use a dremel to cut off the extra.
The chair is against the wall has a long mustache.
I see you are a WESCOG Gunsmith!
The most important thing to be learned from those who demand "Equality For All" is that all are not equal...
Gun Control - seeking a Hardware solution for a Software problem...
You have no idea the fun involved with undoing the fun when somebody did that.
The action was saved, the stock……not so many much.
The most important thing to be learned from those who demand "Equality For All" is that all are not equal...
Gun Control - seeking a Hardware solution for a Software problem...
Posting Permissions
Reply With Quote