Still have to order nearly everything for that upper. Should probably wait until after I get my prognosis regarding the tumors.
Colorado AR-15 Shooters Club Discussion Forums
Welcome to the Colorado AR-15 Shooters Club Discussion Forums.
Welcome to the Colorado AR-15 Shooters Club Discussion Forums.
Still have to order nearly everything for that upper. Should probably wait until after I get my prognosis regarding the tumors.
After that, I want to replace the barrel on my other rifle, thinking of just a BCM 16" midlength barrel. Currently have the factory M&P15 1:9 barrel, but it has a few dremel marks which surely affect the accuracy/harmonics.
Had a very hard time getting that gas block off, so I tried the good ol' fashioned dremel cutoff wheel method. Cut right through and then some. Its not that bad, but still, the barrel was never really all that accurate to begin with.
For the SPR, I'm thinking about getting a Noveske NSR 16.7" rail. Saw a pic of one of those on an 18" SPR and it was supersecksay!!
After that, I have no idea. Might consider getting a nice billet lower, building it as a pistol with a 300aac barrel either 8" or 10" and then filing a stamp to SBR it.
Eventually I think it would be great fun to get a 30cal can for that rifle too. At which point it would be time for a Remington 700 for that can too. And then get into the really long range shooting.
Cause, you know, with the continual knee problems that I have, IPSC probably isn't a good idea.
And now my wish list is kind of empty. Perhaps I'll get new garage doors for our house. We have tilt up doors and they suck.
They don't seal anything out especially rain (not like we get that here often) but mostly bugs, only 1 has a motor on it (that's the fiancee's).
Finally got my personal laptop up and running again. Turns out it wasn't the charger circuit, it was the wall wart.
Posting Permissions
Reply With Quote