The post whore thread.

[wyome]

Is Patrick still fixing and selling Pinz stuffs?

[OtterbatHellcat]

I've got some progress on the gearing/driveshaft stuff I was looking into. The guy wants the output flange from the T-case to see how far the option door is...he wants to cv the front of the rear shaft with the slip. If we can do that we're good. The dana 60 that is already set up with the slide off discs will be fine, he said...and I'm going with 4:56 gearing.

Once that is done, reinstall and then tear out the reverse cut 44 up front and get it matched up, it won't be special a kit for that. I'll get new ball joints for the spindles, and go through all the bearings and hub stuff...replace anything that needs it and get all new seals for everything. I don't really like the lock outs that are on it now, so I'll see what yanks my crank for that. Install new axel joints too. After that is done, have them go through the T case and make sure all that is up to snuff and all resealed.

[wyome]

Ummmm.... your truck is a 4x4 huh

[Mazin]

Can't wait to check it out when it's done, you're going the distance on this one that's for sure!

[Mazin]

I'm IN on this...we could rotate weekends.

Lol time share pinz.....I like it! How much time would $32 get me?

[Mazin]

Is Patrick still fixing and selling Pinz stuffs?

I think so but I haven't taken with him in awhile.

[OtterbatHellcat]

I'm trying brother

[Mazin]

And cabinet doors. Close that shit!

Yea I'm the guilty one on that.....

[OtterbatHellcat]

Lol time share pinz.....I like it! How much time would $32 get me?

10 minutes?

[Mazin]

I'm in!!!