What did you do in the reloading room today?

[Irving]

Thats crazy! When is the next IDPA shoot and are you going?

I was kidding about the jig saw. There is a shoot in Dumont this Saturday, but I haven't been up there in over a year. The next one at CRC is the 4th Saturday of each month, and I plan on going.

[Zach O]

Loaded 100 rounds of match ammo yesterday. Headed out Saturday to confirm zero and true some data to at least 1,000 yards. Hope the wind stays fairly calm while gathering data.

[bobbyfairbanks]

Loaded up some .223 test loads with exterminator and a 55 gr pill. Cleaned the 1050 and then finished off with some9mm test loads

[Slapps74]

Cleaned some more brass. Case feeder on the 650 quit working so got that replaced and set up to load some 45 ACP 200 gn LSWC test loads.

[XC700116]

Sorted 1K Berger 105's by bearing surface length, then prepped 200 pieces of 6X47L brass.

[Tim K]

I walked in and decided the combination of jet lag and a cold was too much. Time for a nap.

[Zombie Steve]

Dood! Take it easy for a few days and get back on Mountain time. We won't chastise you for at least 48 hours.

[Hoser]

We won't chastise you for at least 48 hours.

We? What is this "we" you speak of?

[Zombie Steve]

Oh that's right... I'm good cop, Hoser is bad cop. Git 'em!

[brutal]

Spent an hour removing my first stuck case (partial rim separation) without a removal tool. Sacrificed a decapping rod/pin to get er done.

Ordered a removal tool and a new decapping rod and spare pins.