What did you do in the reloading room today?

[Great-Kazoo]

Chamfered the 308 i had siting in bags. Also giving a try resizing 308 & 243 to 6.5C. Not sure which will work better. Thanks to jmg8550 who's been walking me through the process. I see why the LC isn't going to work. Definitely tight on the neck - chamber area.

[Hoser]

Chamfered the 308 i had siting in bags. Also giving a try resizing 308 & 243 to 6.5C. Not sure which will work better. Thanks to jmg8550 who's been walking me through the process. I see why the LC isn't going to work. Definitely tight on the neck - chamber area.

It will work, but you will have to inside ream the necks our turn the outside of the necks.

[MarkCO]

Shook my head at the mess and disarray.

Right there with you. I have actual guns laying on the floor, about 3K rounds of various ammo scattered around, two projects on the loading bench and the processing bench has stuff stacked all over it too.

Clean then think about reloading.

[jmg8550]

It will work, but you will have to inside ream the necks our turn the outside of the necks.

Yep, the necks need turned down as the brass that was the shoulder area is now the neck area of 6.5Creedmoor. I've found that FC 243 brass works better than LC. I'm going to try Winchester and Remington 308 brass, I have some laying around.

[Great-Kazoo]

Yep, the necks need turned down as the brass that was the shoulder area is now the neck area of 6.5Creedmoor. I've found that FC 243 brass works better than LC. I'm going to try Winchester and Remington 308 brass, I have some laying around.

Trying some PPU & ZQ1 today or tomorrow. An exterior neck sizer is in transit.

[jmg8550]

Neck sizer, or neck turner?

[Great-Kazoo]

Neck sizer, or neck turner?

This unit, any input or suggestions are always helpful & appreciated

http://kmshooting.com/tools/holding/...older-393.html

[jmg8550]

Looks like it'll work. I've never used a neck turning tool.

[Grant H.]

Spent some time casting bullets.

Made up a bunch of 198 gn spritzers for full auto 300 Whisper ammo. Subsonic mag dumps with Sierra 220s gets expensive in a hurry.

I also cast up a bunch of 350gn flat points for plinking ammo for my 416 Rigby.

Now to get them powder coated. I figure the Rigby bullets should be pink so I can hunt pink elephants.

Are you coating them?

If so, care to share any details?

[Hoser]

This unit, any input or suggestions are always helpful & appreciated

http://kmshooting.com/tools/holding/...older-393.html

I have a K&M and a Neilson Pumpkin. Both are excellent.