What did you do in the reloading room today?

[Limited GM]

Restocked into the shop, what I found at wal-mart when I stopped for a case of water. They had all relaoding stuff on clearance except powder and primers. I bought all the above for less than $300. Kazoo got me thinking about powder and some very helpful young guy went and dug around in the back. Sure enough, there was what you see here. $4.5 and up powder and $9 and up Bullets. SCORE!! (No primers were found)

Then last night, a neighbor brings the brass over. Brand new 308 included. SCORE X2!!!!

[Great-Kazoo]

Restocked into the shop, what I found at wal-mart when I stopped for a case of water. They had all relaoding stuff on clearance except powder and primers. I bought all the above for less than $300. Kazoo got me thinking about powder and some very helpful young guy went and dug around in the back. Sure enough, there was what you see here. $4.5 and up powder and $9 and up Bullets. SCORE!! (No primers were found)

Then last night, a neighbor brings the brass over. Brand new 308 included. SCORE X2!!!!

Finders fee

[thedave1164]

Clean up and organize the shelves, now working on the benches.

Inventory complete on powder and primers.

Need to inventory brass and bullets.

Need to inventory factory ammo and reloads.

[thedave1164]

Picked up some varget, tite group, bullseye and primers.

Spent too much money today

[Great-Kazoo]

Trimmed & chamfer a lot of 6.5. Tomorrow ladders

[bobbyfairbanks]

Loaded up 300rds 6mm Creedmoor

[MarkCO]

Finished the reorganize/cleanup. Still have a little more trim work to do on the room itself, but it is close.

[thedave1164]

Cast some Keith style for .45 Colt, loaded up some 124gr FMJ 9mm to replace my stock that just got loaded into mags for my 9mm AR pistol, cast a few 115gr rn 9mm bullets.

Gonna have to work on the temp for casting, I know I am hot, going to see if I can get my PID controller hooked up and working

[asmo]

Measured out my 'project' for the Christmas break...

• 130 lbs of 9mm
• 140 lbs of 5.56
• 50 lbs of 40

Don't think my little tumbler is going to be able to handle this.

[O2HeN2]

Finished mounting the new XL650 I bought as a "Thank gawd, guns are [relatively] safe for another four years" present to me.

The right one for small primers, the left (center) for large since I find changing primer sizes on the 650 a PITA.

Been thinking about buying a second press for a couple years, but quite honestly I thought our [legal] gun owning days were numbered. As such, I wasn't about to sink money into such a frivolous thing as a second press to save myself some hassle.

Well happy day!

O2

Ps. My old 650 is very, very old. They've changed the mounting position of the case feeder on the new one, and I just might have to buy a new case feeder bracket because the new position is much, much better than the old. As would be expected from Dillon.