Nothing the last few days. There's a foot of snow between here and the reloading room.
The Great Kazoo's Feedback
"when you're happy you enjoy the melody but, when you're broken you understand the lyrics".
Got the basic table in place. Next step - sand and seal the top.
Cast a pot of .45's the other day... loaded them up.
Oh, and some 9mm - God, I love 9mm.![]()
Started running one of my tubs of 223/556 through the wet tumbler without pins.
Brass prep is so much nicer after a quick wash/dry.
Why no pins?
Just curious.
Basically just an initial washing to knock all the dirt and grime off before running it through the case feeders and 1050's. Easier on the machines, and makes it easier to spot cases that aren't up to snuff before I spend more time than necessary on them.
My process for range brass is:
1. Wash with soap/hot water
2. Dry
3. Lube, deprime, swage, size, trim
4. Stainless tumble with pins/chips, soap, lemi-shine, etc
5. Load
Thanks. I am about to process a batch of once fired cases that have been in storage for years. I wanted to size and deprime them before I tumbled them but they?re slightly more grungy than I like for running through my dies. Might give the wet tumble a try without the pins and see how that works.
2 Hours in the FA tumbler. Hot water and Great Value "Dawn"...
2 Hours isn't absolutely necessary, but it times well with drying the previous batch in the dehydrator. 1k 223/556 at a shot, 2k 9mm at a shot.
Before:
20210126_211934 by ARNEWB, on Flickr
After:
20210126_211953 by ARNEWB, on Flickr