What did you do in the reloading room today?

[ray1970]

Didn't do anything in the reloading room today but I really need to get on the ball and start putting some .308 loads together. Nice weather is just around the corner and I need to get sighted in and find a load my rifle likes so maybe I can participate in some of the local matches this summer.

[Hoser]

I got my new 1050 set up and adjusted for 300 Blackout and 223. I only had to tweak the primer seating depth and FL resize from the old 1050. I would rather be lucky than good.

[Mazin]

Finally got my new press setup and now I'm going to start working some 223 brass.


Sent from my Otterbox Defended Tactical iPhone using High Capacity "Clips".

[dwalker460]

I decapped and sized a cpl hundred 9mm cases to load up some plated 115's for the upcoming Noveske match, loaded up 30 or so test 300blk's with 125gr Speer OTM's, and loaded 300 5.56 55gr FMJBT's for the Noveske match. Good times.

[bobbyfairbanks]

I built or am in the process of building a new reloading shop. All I need now is a couple of 1050's!

[Dingo]

Stood around with a glum look on my face for a while, and wished I had more reloading components. :-)

[Hoser]

I actually used a single stage press yesterday.

I sized down some Z-Max 123 gn .311 dia bullets to .3085 with my CH4D die. Getting them that .025 smaller took more oomph than I would have thought. Even with lots of Imperial Die Wax.

I also ran a bunch of surplus 175 Sierra (118-LR pulls) through as well.

[Hoser]

All I need now is a couple of 1050's!

You gotta start somewhere.

[Zombie Steve]

You gotta start somewhere.

I'd say his 550 is a damn good start.

[Mazin]

Counting brass and finishing up with the mounting and dialing in of the new press. Once I get though counting the rest of my brass then I will start trimming up some 223. busy night ahead.