Vudoo 360 should be here tomorrow

[FromMyColdDeadHand]

How is it shooting?

My 40X gets a bit persnickety on feeding when in my AICS chassis, but the ACC chassis holds the mags tighter and in a better position- but the mags are in TIGHT. I?m spinning up a CZ457 with a 1x9 Lilja barrel for long range stuff. With the feeding issues, I was thinking about taking the old 40X stock, freshening it up, and cutting it for a badger bottom metal to take mags. Make a nice looking heavy 22lr out of it. thoughts on that, do I have the concept right?

[Wolfshoon]

How is it shooting?

and cutting it for a badger bottom metal to take mags.?

Double check that the badger will hold voodoo mags. The two badger DBM M5 pattern bottom metals I tested with Paul at MHSA dropped right through with no engagement of the release lever at all. That is why I went with Hawkins DBM metal.

[FromMyColdDeadHand]

Double check that the badger will hold voodoo mags. The two badger DBM M5 pattern bottom metals I tested with Paul at MHSA dropped right through with no engagement of the release lever at all. That is why I went with Hawkins DBM metal.

What kind of stock did you put this into? Thanks for the insights