milled AK help

[bryjcom]

the stamped kit got sold once I got this kit...this one was complete with underfolding stock and the trigger guard and all the other parts.

Now I need to find a stamped kit and make a trade or sell this one and find a complete stamped kit.

Expect to pay quite a bit on top of the trading the kit if you want a stamped underfolder.

I think a virgin underfolder is going for around $500 and you half to drill the gas port, barrel/sightblock/gas block/front sight pin holes, the trigger gaurd and probable lots of other things. You also have to headspace the barrel properly before you drill the barrel pin hole.

People at the party would be able to help but it would probably be harder to do that one then make a bad-ass milled AK.

[DOC]

Is there a place that sells milled receivers? If you can buy a premade one it could be as easy as installing the parts!!

[sniper7]

Is there a place that sells milled receivers? If you can buy a premade one it could be as easy as installing the parts!!

i have been looking but nothing so far

[bryjcom]

This is the only milled AK section I know of. Its not a full reciever so it requires cleaning up the demilled portions and welding to the new section.

https://www.apexgunparts.com/product...anq64uscemfkk6

I have also seen someone do a stamped build out of a milled AK.

They basically grind or mill the receiver sections down to make a trunnion and then slide them into a stamped reciever. Drill holes in the reciever and spot weld the milled "trunnions" into place.

[Fal Grunt]

Ohio Rapid Fire sells an M70 receiver. If you have an M64 the wiselite solution is about it.

If you think about the Ohio Rapid Fire, please, be sure to do plenty of research before deciding one way or another.

-myers

[Great-Kazoo]

Expect to pay quite a bit on top of the trading the kit if you want a stamped underfolder.

I think a virgin underfolder is going for around $500 and you half to drill the gas port, barrel/sightblock/gas block/front sight pin holes, the trigger gaurd and probable lots of other things. You also have to headspace the barrel properly before you drill the barrel pin hole.

People at the party would be able to help but it would probably be harder to do that one then make a bad-ass milled AK.

i'd like to attend. sent you an em

[bspring]

CNC Warrior also makes machined receivers.

Bill