HAM Radio Discussion

[rbeau30]

Another forum said that the Kenwood software is pretty good so I'm going to check that out before I spend any $$ on the RT stuff.

Got all my stuff in the mail today besides the antenna which I'm going to grab from HRO tomorrow. Looks like I'll need an extension cable for the microphone and the data to the head as it isn't long enough to reach the back seat - so I'll be grabbing that tomorrow as well.

I have heard CAT5 straight through works.

[kawiracer14]

I have heard CAT5 straight through works.

That's much cheaper. I'll try that.


Sent from my pocket

[ChadAmberg]

I have heard CAT5 straight through works.

CAT5 straight through does work, but you must check the pinouts to make sure it's a passthrough, pin 1 goes to pin 1, 2 to 2, etc. So you'll most likely want to crimp it yourself.

[rbeau30]

CAT5 straight through does work, but you must check the pinouts to make sure it's a passthrough, pin 1 goes to pin 1, 2 to 2, etc. So you'll most likely want to crimp it yourself.

Plus you can get all the hip new designer CAT5 colors and color coordinate for the occasion!

I gotta crimper and tester if anyone needs to borrow. I used to do that for a living.

[kawiracer14]

Plus you can get all the hip new designer CAT5 colors and color coordinate for the occasion!

I gotta crimper and tester if anyone needs to borrow. I used to do that for a living.

Ohhh red to match my truck! Ha.

Its all going to be run where it can't be seen. The only things visible will be the head unit, the mic, and my CB.

[rbeau30]

Ohhh red to match my truck! Ha.

Its all going to be run where it can't be seen. The only things visible will be the head unit, the mic, and my CB.

That is how I attempted. I tried to use some "SAFCord" but my carpet wasn't loopy so it won't stick. and I am too lazy to fish the wires under the carpet. I might just put all the cords through the plastic conduit stuff.