POI change with Thunderbeast 30p1

[asmo]

Here is a picture of my shot placement difference between suppressed and unsuppressed using a TBAC 30BA. My point of aim (and impact when unsuppressed) is the bottom left tip of the triangle.

This is a 5 shot group at 100m, removing the suppressor and putting it back on - twice. In other words - very repeatable.

[TriggerHappy]

Ok. Maybe my question was confusing. Where is your un-suppressed group and your suppressed group? Shoot holding center, then can it, shoot holding center. How much MOA difference?

Here is a picture of my shot placement difference between suppressed and unsuppressed using a TBAC 30BA. My point of aim (and impact when unsuppressed) is the bottom left tip of the triangle.

This is a 5 shot group at 100m, removing the suppressor and putting it back on - twice. In other words - very repeatable.

[asmo]

Ok. Maybe my question was confusing. Where is your un-suppressed group and your suppressed group? Shoot holding center, then can it, shoot holding center. How much MOA difference?

No your question wasn't confusing - I was just a dumb ass and didn't take a picture of the target I was shooting at un-suppressed. We were taking the suppressor on and off looking for repeatability so I was shooting at one target with the suppressor on and another target with the suppressor off.

The unsupressed target was identical (on the same board right next to the one I took pictures of) but I was aiming at the corner of the triangle on it. The group was similar (one flyer about an inch high and 1/4 left). Next time I go out (and remember) I will take pictures of both targets (or just use the same target now that I know that they aren't wildly off).

Sorry for the delay in the response - I forgot about the thread.